Dream Spa

Up until recently, there were two types of filtration pump systems available. The first was a two speed pump which filtered on low speed and switched to high speed when the jets were turned on. Two speed pumps are still available, but the pumps are usually more noisy and less reliable.

The second system was a very small circulation pump which ran 24 hours a day regardless of whether you needed it to or not. Arcadia instead uses a programmable circulation pump. It is quieter and more reliable than a two speed pump, but can be programmed to run for between 2 and 24 hours per day depending on how much the spa is being used.

The heater of your spa draws more power than any other component. As a result, when the big jet pump or pumps turn on, the heater usually has to turn off, as unless your spa is hard wired, a conventional outdoor power point cannot provide enough power to run the heater and big jet pump at the same time.

Arcadia however, use a variable output heater. This means when the spa's jet pump is turned on, the heater turns DOWN rather than OFF. This has the benefit of maintaining the spa's temperature while you are using it, rather than cooling it down.

As heat rises, most of the heat loss in a spa occurs through the spa's cover. As such, it is important that the spa's cover is manufactured from a high density foam that has better heat retention properties. All Arcadia Spas uses a high density foam insert which is also heat shrink sealed to prevent water ingress, prolonging the cover's life.

There are several ways to insulate a spa. Arcadia spas have chosen to use perimeter insulation. Whilst more expensive to produce than foaming the shell of the spa, it does have the benefit of insulating the water that is in the plumbing of the spa, as well as the water in the spa itself.

Acting like double glazed windows, the dual layer insulation system traps air between the foam insulation on the shell and the reflective foil and foam insulation of the cabinet, to create a pocket of warm air.

This system ensures that not only the water in the spa is insulated, but also the water in the pipework. This option adds a higher level of heat retention than Arcadia’s standard perimeter insulation.